1. Home
  2. Components
  3. Threaded posts

Threaded post generator

Choose the thread size, body length and round or hex body, then pick each end: tapped hole, threaded stud or plain. Female-female, male-female and male-male standoffs, with ISO thread callouts on the drawing.

—
Drag to rotate, scroll to zoom
Loading 3D viewer…
Envelope (mm)
—
Volume
—
Est. mass
—
Material
—

Notes for threaded posts

  • Type "M3 hex standoff 20mm long, 5.5 across flats" or "M6 threaded post 60mm long with studs both ends".
  • Tapped holes are modelled at the tap drill size (e.g. Ø4.2 for M5) and called out on the drawing as M5 × 0.8 - 6H; studs are modelled at the nominal size and called out 6g.
  • For 3D-printed posts, use heat-set inserts or tap the printed hole; the model does not include thread geometry.
Brass male-female hex standoff and a stainless female-female standoff
Brass male-female hex standoff and a stainless female-female standoff (render)

Other categories

Mounting plates

Rectangular plate with rounded corners and a hole pattern.

Length, width, thickness, corner radius, hole patterns

Blocks

Rectangular block with through holes in any pattern.

Length, width, height, hole patterns

Spacers

Round spacer / standoff with a clearance bore.

M2 to M20 clearance bores, any length

Washers

Flat washer or shim with any OD, ID and thickness.

Outside and inside diameter, thickness

Made in the Mechform Factory, soon

Any part you configure will be made in our AI-run automated factory, 3D printed or machined, with the price and lead time worked out from the model itself. Ordering isn't open yet.